Difference between revisions of "20.109(S17):Purification of induced protein (Day2)"
From Course Wiki
Noreen Lyell (Talk | contribs) (→Part 1: Lyse BL21(DE3)pLysS pRSETb_FKBP12 cells) |
Noreen Lyell (Talk | contribs) (→Part 1: Lyse BL21(DE3)pLysS pRSETb_FKBP12 cells) |
||
| Line 35: | Line 35: | ||
| 1 M AEBSF | | 1 M AEBSF | ||
| 1 mM | | 1 mM | ||
| − | |||
| − | |||
| − | |||
| − | |||
| | | | ||
|- | |- | ||
| Line 46: | Line 42: | ||
|} | |} | ||
</center> | </center> | ||
| + | #Confirm your calculations with the teaching faculty. | ||
| + | #Weigh each cell pellet using the balance and add 1 mL of lysis buffer per g of cell pellet. | ||
| + | #*Note: the weight of the 2 mL eppendorf tube is 1.1g. | ||
| + | #Resuspend each pellet completely in the lysis buffer. | ||
| + | #Add lysozyme (stock concentration of 50 mg/mL) to each cell resuspension such that the final concentration is 300 μg/mL. | ||
| + | #Incubate in the 4 °C cooler for 1 hr on the nutator. | ||
===Part 2: Purify FKBP12 protein=== | ===Part 2: Purify FKBP12 protein=== | ||
Revision as of 23:51, 3 January 2017
Contents
Introduction
Protocols
Part 1: Lyse BL21(DE3)pLysS pRSETb_FKBP12 cells
- Retrieve your BL21(DE3)pLysS pRSETb_FKBP12 cell pellet from the front laboratory bench and leave them on your bench to thaw.
- You will also obtain a cell pellet of uninduced cells that was prepared by the teaching faculty as a control to examine the IPTG induction step.
- Prepare 3 mL of lysis buffer.
- Use the information in the table below to calculate the volume of each stock reagent that is needed to prepare the lysis buffer with the specified final concentrations:
| Stock reagent | Final concentration of stock reagent in lysis buffer | Volume of stock reagant |
|---|---|---|
| 1 M Tris (pH = 7) | 50 mM | |
| 1 M NaCl | 150 mM | |
| 40% glycerol | 10% | |
| 1 M DTT | 1 mM | |
| 1 M AEBSF | 1 mM | |
| H2O | add for a total of 3 mL of lysis buffer |
- Confirm your calculations with the teaching faculty.
- Weigh each cell pellet using the balance and add 1 mL of lysis buffer per g of cell pellet.
- Note: the weight of the 2 mL eppendorf tube is 1.1g.
- Resuspend each pellet completely in the lysis buffer.
- Add lysozyme (stock concentration of 50 mg/mL) to each cell resuspension such that the final concentration is 300 μg/mL.
- Incubate in the 4 °C cooler for 1 hr on the nutator.
Part 2: Purify FKBP12 protein
Reagents
Next day: Evaluation of purified protein
Previous day: In silico cloning and induction of protein expression